CLOCKstep:MULTI Firmware 1.0.0058 Released

CLOCKstep:MULTI Firmware 1.0.0058 Released

Firmware 1.0.0058 has been released with the following new features:

Latency Compensation

Allows for positive and negative offset while an external clock source is being used.  This feature helps mitigate timing issues that may arise using a DAW and an external sequencer.  By setting a negative offset, the external sequencer receives an adjustment for clock and transport commands that enable it to match the playback of other tracks within the DAW.  See the new chapter titled:  Latency Compensation.

MIDI Quantize

An addition to the MIDI Command implementation, MIDI Quantize adds the ability to capture a MIDI Message as it comes in and send it at the top of the next Bar.  Up to 32 MIDI Messages can be quantized at once.  See the new chapter titled:  MIDI Quantize

MIDI Repeat

An addition to the MIDI Command implementation, MIDI Repeat adds the ability to capture a MIDI Message as it comes in and repeatedly resend it after a given number of Bars have elapsed.  Up to 4 MIDI Messages can be repeated.  See the new chapter titled:  MIDI Repeat.

 "External" Transport Mode

This new Transport Mode is intended as a convenience for use when external clock is being received.  It will automatically send the transport Start command upon detection of clock pulses.  The chapter titled Transport and Clock has been updated.

Other Changes:

Global Settings

When navigating to the Global Settings by holding the Preset button, you can make on the fly adjustments of Global Settings while continuing to run your project.  In prior builds, the clock and metronome functions would stop if Global Settings were viewed.

MIDI IN and MIDI THRU Adjustment

In prior builds, MIDI THRU would only function if MIDI IN was enabled.  That's no longer the case.  MIDI IN and MIDI THRU have discrete behaviors that no longer impact each other.

  • MIDI IN:  When enabled, CLOCKstep:MULTI will respond to remote MIDI Commands targeting it's own MIDI Channel.
  • MIDI THRU:  When enabled, CLOCKstep:MULTI will send all MIDI Messages THRU.

Bug Fixes:

The Audio Calibration indicators were not functioning correctly since the release of 1.0.0052.

Presets could not be saved without a Time Signature setting.

USB MIDI THRU was not functioning correctly.

 

 

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.